Contact Us

C o n t a c t U s

replacement of aggregate by granite stone in concrete

Concrete is prepared with granite fines as a replacement of fine aggregate in 5 different proportions namely 5%, 15%, 25%, 35% and 50% and various tests such as compressive strength, Split tensile strength and Flexural strength are investigated and these values are compared with the conventional concrete without granite fines

replacement of aggregate by granite stone in concrete

[2] reported approximately 23% lower initial tangent modulus ( E it ) for brick aggregate concrete than that of granite aggregate concrete.The reduction in tensile strength of mixed aggregate concrete is found to be less significant up to 50% replacement of stone aggregate by brick aggregate.

Replacement Of Aggregate By Granite Stone In

Replacement Of Aggregate By Granite Stone In Concrete Effect of Recycled Glass Powder as Fine Aggregate on the . 2018-5-29 waste glass was used to replace natural sand in concrete. This project examines the effect of replacement of fine aggregates with recycled glass on the mechanical properties of Portland The fine aggregate for making concrete is the natural sand mined from the riverbeds.

Geo Polymer Concrete with the Replacement of Granite

2020-4-1  Kanmalai Williams C et al (2008) examined the performance of concrete made with the granite powder as fine aggregate. Sand was replaced with granite powder in steps of 0, 25, 50, 75 and 100% and cement was replaced with 7.5%Silica fume, 10% fly ash and 10% slag. They added 1% super plasticizer to improve the workability. The effects of curing temperature at 320 C and 1, 7, 14, 28, 56 and 90 days compressive strength, split tensile strength, modulus of elasticity, drying shrinkage and water penetration depth were found. Experimental results indicated that the increase in the in a decrease in proportions of granite powder resulted the compressive strength of concrete. The highest compressive strength was achieved in samples containing 25% granite powder concrete, which was 47.35 KPa after 90 days. The overall test performance revealed that granite powder can be utilized as a partial replacement

A Study on Partial Replacement of Natural Granite

2014-12-16  ABSTRACT : In this paper the use of pelletized fly ash aggregate in concrete as a partial replacement of granite aggregate has been examined. The concrete so produced is light weight in nature and the development of such concrete with cold bonded pelletized fly ash aggregate is to minimize the conventional aggregate, which results in protection of the natural environment. With the partial replacement (0%, 25%, 50%, 75% and 100%) of natural granite aggregate

Experimental Study on Partial Replacement of Fine

2016-5-14  Therefore, granite fines can be effectively used as a replacement material for fine aggregate in concrete. For investigation purpose cubes are casted with 7 different proportions of granite fines and fine aggregate.

STUDY OF PARTIAL REPLACEMENT OF FINE AGGREGATE

2018-3-15  In the production of concrete, granite/basalt stone and river sand are used as cou rse and fine aggregate, respectively although these materia ls are usually available, at some places it is economical to substitute these materials by locally available onc e.

Partial Replacement of Coarse Aggregate with Broken

2018-8-12  sumption of natural resources (Crushed Granite) used in pro-ducing concrete which in turn will reduce environmental & human hazards arising from crushing granite. On the other hand, using ceramic waste as a partial replacement of coarse aggregate will reduce the volume of

Replacement Of Coarse Aggregate In Concrete [Civil

2021-7-13  Using the E-waste as a partial replacement of coarse aggregate in concrete is the best solution. We can not fully replace material in concrete because it impacts the workability of concrete . The electronic waste is crushed as required particle size and can be mixed with other aggregates in concrete which will not affect the quality & durability of the concrete.

AN EXPERIMENTAL ANALYSIS OF PARTIAL REPLACEMENT

2018-3-24  performance of the concrete was determined by undergoing slump test,compressive strength test, flexural strength. From the results of the study, samples of concrete with 20% & 30% ceramic coarse aggregate replacement has reached optimum strength. Findings showed that concrete International Journal of Pure and Applied Mathematics

Geo Polymer Concrete with the Replacement of Granite

2020-4-1  granite fines content was the optimum value for improved structural performance. Kanmalai Williams C et al (2008) examined the performance of concrete made with the granite powder as fine aggregate. Sand was replaced with granite powder in steps of 0, 25, 50, 75 and 100% and cement was replaced with 7.5%Silica fume, 10% fly ash and 10% slag.

Review Paper on Partial Replacement of Fine Aggregate

2018-4-20  Review Paper on Partial Replacement of Fine Aggregate by Industrial or Mine Waste in Concrete Devang G Dangodara1, concrete with granite powder had a slump equal to 80 mm where the coarse aggregate is crushed stone (stone chips).

A Study on Partial Replacement of Natural Granite

2014-12-16  conventional aggregate, which results in protection of the natural environment. With the partial replacement (0%, 25%, 50%, 75% and 100%) of natural granite aggregate by pelletized fly ash aggregate, the strength properties of concrete such as compressive strength, split tensile strength,

Replacement Of Coarse Aggregate By Granite Stone

replacement of aggregate by crushed granite stone while crushing rock into aggregate at stone crushing plants. crushed granite is in abundance and river sand is scarce, the complete . Read moreDepartment of Civil Engineering University of Ilorin Ilorin, Nigeria6.52 Мб The firie aggregates and quarry dust are surface dried before use.

Partial Replacement of Coarse Aggregate with Broken

2018-8-12  Partial Replacement of Coarse Aggregate with Broken Ceramic Tiles in Concrete Production Yiosese A. O., Ayoola A. R., Ugonna M. C., Adewale A. K. Abstract— The study reports on experimental investigation on the suitability of the use of broken tiles as partial replacement for crushed granite in concrete production.

Utilization of Recycled Concrete Aggregates in Stone

2014-12-17  Utilization of recycled concrete aggregates as a total replacement of virgin granite aggregate in porous asphalt mixtures was investigated by Chen and Wong . In this research, Draindown, Cantabro, Marshal, permeability, and ageing tests were carried out to evaluate the performance of the porous asphalt mixtures.

A Study on Utilization Aspects of Stone Chips as an

2017-2-8  A Study on Utilization Aspects of Stone Chips as an Aggregate Replacement in Concrete in Indian Context Saiyed Farhana1, Parmar Bhumika2, Prajapati Jayesh3, Prof. Jayeshkumar Pitroda4 1,2,3Students of final year B.E. Civil Engineering,B.V.M. Engineering College, VallabhVidyanagar

An Experimental Study on Partial Replacement of Sand

2016-3-3  Out of the replacement percentages of 10% to 50%, the highest strength was achieved at 30% in compressive, split and flexural strength. Divakar et al10. (2012) have experimented on the behaviour of M20 grade concrete with the use of granite fines as a partial replacement for sand in 5%, 15%, 25%, 35% and

The Utilization Of Crushed Stone Dust As A

The manufacture of coarse granite/basalt stone and river sand are used as aggregate by rushing stone ballast produce large coarse and fine aggregate, respectively. Although amount of crushed stone dust as waste material. these materials are usually available, at some places This poses a

Use of Quarry Dust to Replace Sand in Concrete An

2021-6-4  Coarse aggregate of 20mm maximum size is used in Reinforced cement concrete work of all types of structures. This is obtained by crushing the stone boulders of size 100 to 150mm in the stone crushers. Then it is sieved and the particles passing through 20 mm and retained on 10mm sieve known as course aggregate.

Geo Polymer Concrete with the Replacement of Granite

2020-4-1  granite fines content was the optimum value for improved structural performance. Kanmalai Williams C et al (2008) examined the performance of concrete made with the granite powder as fine aggregate. Sand was replaced with granite powder in steps of 0, 25, 50, 75 and 100% and cement was replaced with 7.5%Silica fume, 10% fly ash and 10% slag.

A Study on Partial Replacement of Natural Granite

2014-12-16  conventional aggregate, which results in protection of the natural environment. With the partial replacement (0%, 25%, 50%, 75% and 100%) of natural granite aggregate by pelletized fly ash aggregate, the strength properties of concrete such as compressive strength, split tensile strength,

Replacement Of Coarse Aggregate By Granite Stone

replacement of aggregate by crushed granite stone while crushing rock into aggregate at stone crushing plants. crushed granite is in abundance and river sand is scarce, the complete . Read moreDepartment of Civil Engineering University of Ilorin Ilorin, Nigeria6.52 Мб The firie aggregates and quarry dust are surface dried before use.

Utilization of Recycled Concrete Aggregates in Stone

2014-12-17  Utilization of recycled concrete aggregates as a total replacement of virgin granite aggregate in porous asphalt mixtures was investigated by Chen and Wong . In this research, Draindown, Cantabro, Marshal, permeability, and ageing tests were carried out to evaluate the performance of the porous asphalt mixtures.

PARTIAL REPLACEMENT OF COARSE AGGREGATES BY

2017-2-16  The ingredients of concrete were Expanded Polystyrene beads in the form of spheres, (used for filling bean bags), River sand as fine aggregate, crushed granite stones as coarse aggregate, 43 grade Ordinary Portland Cement conforming to I.S: 8112 and water. The physical properties EPS beads related to the work are shown in Table1.

An Experimental Study on Partial Replacement of Sand

2016-3-3  Out of the replacement percentages of 10% to 50%, the highest strength was achieved at 30% in compressive, split and flexural strength. Divakar et al10. (2012) have experimented on the behaviour of M20 grade concrete with the use of granite fines as a partial replacement for sand in 5%, 15%, 25%, 35% and

The Utilization Of Crushed Stone Dust As A

The manufacture of coarse granite/basalt stone and river sand are used as aggregate by rushing stone ballast produce large coarse and fine aggregate, respectively. Although amount of crushed stone dust as waste material. these materials are usually available, at some places This poses a

Use of Quarry Dust to Replace Sand in Concrete An

2021-6-4  Coarse aggregate of 20mm maximum size is used in Reinforced cement concrete work of all types of structures. This is obtained by crushing the stone boulders of size 100 to 150mm in the stone crushers. Then it is sieved and the particles passing through 20 mm and retained on 10mm sieve known as course aggregate.

AGGREGATES AND POZZOLANIC MATERIALS OVERVIEW

2018-4-10  Aggregate plays an important role in the resistance of concrete to surface abrasion and wear. Good aggregate is hard, dense, strong, and free of soft, porous, or friable particles. Abrasion resistance of aggregate can be tested by the Los Angeles test (ASTM C131 and C535). Micro-Deval test (CSA A23.2 -23A) similar to LA Abrasion

Fresh and hardened properties of high-strength

2021-2-10  This paper presents the fresh and hardened properties of high-strength concrete comprising byproduct fine crushed aggregates (FCAs) sourced from the crushing of three different types of rocks, namely granophyre, basalt, and granite. The lowest void contents of the combined fine aggregates were observed when 40% to 60% of natural sand is replaced by the FCAs. By the replacement